Century Helicopter Products Hummingbird Elite 3D Pro, Сборка и инструкция по эксплуатации

Страница: 10 / 12

13-2
Tail Rotor
Blade
#CNE322
M2x7 Machine
Screws
#CNE317
Rudder Pushrod
#CNE316
Tail Blade
Grip
#CNE324
M2x7 Machine
Screws
#CNE317
Vertical Fin
#CNE317
M2x4
Machine
Screw
#CNE317
13-1
Tail Pitch
Slider Arms
M2x6 Machine
Screws
#CNE324
M2x6 Machine
Screws
#CNE324
Tail Rotor
Hub
#CNE318
Tail Pitch
Lever
#CNE321
Tail Pitch Slider
Pin Mount
M2x4 Machine
Screw
#CNE321
M2x8 Machine
Screw #CNE321
Tail Pitch
Slider Pin
Tail Blade
Grip
#CNE324
LOCKTITE
Tail gearbox assembly (13-1, 13-2)
52) Attach CNE317
Vertical Fin
to the
Tail Gearbox
left side using the
included M2x7.5 Self Tapping Screws . Finish assembling the Tail
Gearbox by installing the M2x7 Machine Screw found in parts bag
CNE321 to the back end of the Tail Gearbox .
53) Attach the long arm of the
Tail Pitch Lever
to
The Rudder Pushrod
using the M2x4 Machine Screw . Attach the short arm to the Tail
Pitch Slider Pin on the Tail Pitch Slider . Attach the center to the
Tail Pitch Lever Mount on the Tail Gearbox .
54) Assemble CNE324
Tail Blade Grips
to the
Tail Rotor Hub
. Use
locktite on the included M2x6 Machine Screws to attach the Tail
Blade Grips into place. Attach the Tail Blade Grip Arms to the Tail
Pitch Slider Arms using the provided M2x6 Machine Screws .
55) Install CNE322
Tail Rotor Blades
to the
Tail Blade Grips
using
the provided M2x7 Machine Screws . The curved (leading edge)
portion of the Tail Rotor Blades must turn clockwise when viewing
the helicopter from the right side.
10
Note) CNE209 is not used
until the 3D Pro 95% ARF
instruction manual.
After completing step 55 check over each
step for completeness and continue to the
3D Pro 95% ARF Instruction manual to set
up and install electronics.
Section 13: Tail Rotor Assembly
Bags Used:
CNE321, CNE317, CNE324, CNE322
Your new equipment is warranted to the original purchaser against manufacturer defects in material and workmanship for 30 days from
the date of purchase. During this period, Century Helicopter Products will repair or replace, at our discretion, any component that is
found to be factory defective at no cost to the purchaser. This warranty is limited to the original purchaser and is not transferable.
This warranty does not apply to any unit which has been improperly installed, mishandled, abused, or damaged in a crash, or to any unit
which has been repaired or altered by any unauthorized agencies. Under no circumstances will the buyer be entitled to consequential or
incidental damages. This limited warranty gives you specific legal rights. You also have other rights which may vary from state to state.
WARRANTY INFORMATION