GB
Following the cleaning of the upper compartment of
the exchange section, store the upper closure cover.
This cover must be closed, as well as with normal screws,
with webbing in ceramic fiber rope to ensure the
watertight closure of the
boiler
.
This general cleaning should be carried out at the end
of the season in order to facilitate the general removal
of all residues of combustion, without waiting too long,
because with time and humidity these residues can
become compacted.
Check the seal of the ceramic fiber gaskets on the door of
the
boiler
.
Then clean the flue system especially near the fittings to
“T” and any horizontal sections.
For your safety, the frequency of cleaning
the smoke discharge system must
be determined on the basis of how
the
boiler
is used.
In case of failure or inadequate cleaning of the heater
may have function problems such as:
• poor combustion
• blackening of the glass
• clogging of grate with accumulation of ash and pellets
• ash deposit and excessive deposits on the heat ex-
changer resulting in poor performance.
The check of electromechanical components must be
performed only by qualified personnel with technical
knowledge of electricity and combustion.
Surface cleaning
The
boiler
is a product by heating, presents the
external surfaces particularly hot.
For this reason, we recommend extreme caution when
operating in particular:
• Do not touch the
boiler
body and the various
components, do not approach the door, it could cause burns;
• Do not touch the exhaust fumes;
• Do not perform any type of cleaning;
• Do not dump the ashes;
• Do not open the ash tray;
• Be careful that children do not come close.
All cleaning of all parts must be carried out with the
boiler
completely cold and the plug disconnected.
To clean the surfaces, use a rag dampened with water or
with water and a neutral detergent.
These operations must be performed by a
qualified technician, or the user who will
take responsibility in the event of damage
during maintenance.
Perform this maintenance heater cold and in the
absence of electricity. If such maintenance is
performed by an authorized service center is the
responsibility of the customer.
The transaction can be completed with a screwdriver by
removing the wall of the
boiler
and removing all
horizontal joints.
We recommend that an annual maintenance service
is carried out, preferably under a programmed service
contract. The essential part of this service is a visual and
functional check on the following components:
• reduction motor
• smoke expulsion fan
• smoke sensor
• heat-exchanger fan
• ignition sparkplug
• resettable pellet thermostat
• room temperature sensor
• pressostat
• motherboard
• fuse protecting panel - motherboard
The use of aggressive detergents or
thinners can damage the surfaces of the
boiler
. Before using any detergent it
is advisable to try it on a small section out of sight
or contact the Authorized Assistance Centre
for information regarding the product.
