11
3.
You will find a strain relief bracket in the accessory package. Fix the power supply
cord below the bracket, as shown in the previous illustration.
4.
The other end of the power supply cord should be connected to an outlet that is in
accordance with the local electrical code.
Note
：
This machine is stackable on any of the machine in this manual. If the machine is
to be stacked on top of another machine, a stacking kit will need to be installed. Refer to
the installation instructions included with the stacking kit.
Water Supply
The water supply should be ready at the point of installation. The water supply pressure
should be a minimum of 15 psig with a static pressure not more than 80 psig. (A wall outlet
directly behind the ice maker will make installation easier.)
IMPORTANT:
1.
All installations must be in accordance with local plumbing code requirements.
Professional installation is recommended.
2.
Water inlet fitting: 3/8
″
FPT (Female Pipe Thread);
drain line connection: 1/2
″
FPT.
3.
Make certain that you have a proper water supply and a proper drain hose, the hoses are
not pinched or kinked or damaged during installation.
4.
Check for leaks after connection.
Tools required: 3/8
″
open-end wrench, Phillips screwdriver
Connecting the water line:
1.
Turn off main water supply.
2.
Find a water supply line near the installation location. The distance should be less than the
length of the water supply hose.
3.
A shut-off valve must be installed to the main water supply.
4.
Connect the water supply hose to tap and water inlet valve. Tighten firmly by hand, then
one-half turn with wrench.
5.
Connect the water drain hose to drain line connection. Tighten firmly by hand, then
one-half turn with wrench.
6.
Turn on main water supply and tap. Check for water supply connection leaks. Tighten
every connection (including connections at the water inlet).
Installation Types
This ice maker has only been designed for mobile (free-standing) installation. There must be
adequate air space around the unit for ventilation purposes. (See page 7.)
Mobile installation:
A mobile installation will allow you to install the ice maker free-standing in any place you
desire provided you have access to a water supply. You must follow the stated instructions
for
a.
Electrical requirements
b.
Water supply
c.
Drainage
Cleaning before use
After you remove all tape from the machine, clean the inside of your ice maker and ice
storage bin before using them. See “Interior Cleaning″ in the
Cleaning and Maintenance
section.
