Page 7
SKU 97956
For technical questions, please call 1-800-444-3353.
INITIAL TOOL SET up/
ASSEMBLY
Read the ENTIRE IMpORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
This air tool may be shipped with a
•
protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO pREVENT
ExpLOSION:
use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
Tool
Air
compressor
Quick
coupler
Air Hose
on Reel
Filter
Regulator with
pressure Gauge
Male
connector
Male
connector
Valve
Quick
coupler
Recommended Air Line components
Oiler
1. Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,
and filter for best service, as shown
in the diagram above.
An in-line
shutoff valve is an important
safety device because it controls
the air supply even if the air hose
is ruptured.
Note:
If an automatic oiler system is not
used, add a few drops of Pneumatic
Tool Oil to the airline connection
before operation. Add a few more
drops after each hour of continual
use.
Attach an air hose to the
2.
compressor’s air outlet. Connect
the air hose to the air inlet of the
tool. Other components, such as
a connector and quick coupler (not
included), will make operation more
efficient, but are not mandatory.
WARNING! TO pREVENT SERIOuS
INjuRY FROM AccIDENTAL
OpERATION:
Do not install a female quick
coupler on the tool.
Such a coupler
contains an air valve that will allow
