SKU 96318
For technical questions, please call 1-800-444-3353.
PAGE 9
OPERATING INSTRUCTIONS
NOTE:
For additional references to the parts listed in the following pages, refer to the
Assembly Diagram.
Pre-Start Checks:
1.
Unfold Handle Assembly (upward) and secure with Locking Grip (61) on each
side.
2.
Read and adhere to all safety warnings and instructions presented in the Robin
Subaru Engine Manual. (Model Ex-13)
3.
Check to make sure the Engine’s Power Switch is in its “OFF” position.
IMPORTANT!
Prior to initial use, the Plate Compactor’s Engine MUST be filled with
approximately 3/4 quart of a high quality SAE 10W-30 grade engine oil.
4.
Unscrew and remove the Engine’s Oil Fill Plug located at the bottom of the Engine
Crankcase.
5.
Fill the Engine’s Crankcase until the oil level is level with the Oil Fill Hole.
6.
Screw the Oil Fill Plug back into the Oil Fill Hole. (For additional information, refer
to the engine manufacturer’s manual.)
7.
Before first use, remove the Engine’s Fuel Tank Cap and fill the Fuel Tank with
unleaded gasoline. Replace the Fuel Tank Cap. Thereafter, check the Fuel Tank
for the amount of unleaded gasoline before each use. Refill the Fuel Tank only
with unleaded gasoline.
To Start And Operate The Plate Compactor:
1.
Open the Fuel Valve on the Engine and the Throttle (65) on the Handle (66).
2.
Turn the Choke Lever on the Engine to its “CHOKE” position.
3.
Set the Speed Control Lever to its “LOW” position.
4.
Turn the Engine’s Power Switch to its “ON” position.
5.
Grip the Start Handle of the Engine loosely and pull it slowly several times to allow
the gasoline to flow into the Engine’s carburetor. Pull gently on the cord until
pressure is felt. Release the cord to retract. Hold the handle and pull hard and fast
to start the engine. Pull the cord all the way out, using two hands if necessary. If
necessary, pull the cord several times until the Engine starts.