SKU 96318
For technical questions, please call 1-800-444-3353.
PAGE 10
5.
6.
Allow the Engine to run for several seconds. Then, turn the Choke Lever to its
“RUN” position. Adjust the Throttle to appropriate speed.
7.
Grip the Upper Handle (66) firmly with both hands. To avoid injury, keep hands,
fingers, and feet away from the Compactor base. Grip the Handle of the Compactor
firmly with both hands. If both hands are holding the Handle and your feet are clear
of the Compactor Base, your hands, fingers, and feet cannot be injured by the Base
Plate (1).
8.
Adjust the Speed Control Lever between its “LOW” to “HIGH” position, depending
on the desired vibration speed.
9.
Slowly guide the Plate Compactor in the desired direction.
10.
Always keep a safe distance away from the edge of ditches and avoid any actions
that may cause the Plate Compactor to topple over.
11.
Always ascend slopes carefully in a direct path and back up slopes to prevent the
Plate Compactor from toppling back onto the operator.
12.
To Stop The Plate Compactor: Turn the Speed Control Lever to its “LOW” position,
and turn the Engine’s Power Switch to its “OFF” position.
13.
Close the Fuel Valve on the Engine.
INSPECTION, MAINTENANCE, AND CLEANING
1.
CAUTION!
Always make sure the Engine’s Power Switch is in the “OFF” position
when performing inspection, maintenance, or cleaning. Disconnect the spark plug
wire from the engine. Allow sufficient time for the Engine to completely cool before
performing any inspection, maintenance, or cleaning on the Plate Compactor and/or
Engine.
2.
Before each use, inspect the general condition of the Plate Compactor. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts, and
any other condition that may affect its safe operation. If an Engine problem occurs,
always have the Engine immediately checked out by a qualified service technician
before further use.
Do not use damaged equipment.
3.
Before each use, check to make sure the engine’s oil level is full. If necessary, add
oil until the level is even with the Oil Fill Hole.
4.
Before each use, remove all debris from the Plate Compactor with a soft brush,
vacuum, or compressed air. Then use a premium quality lightweight machine oil
to lubricate all moving parts.