Page 9
For technical questions, please call 1‑800‑444‑3353.
SKU 68150
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Turn the Power
Switch of the tool off and unplug
the tool from its electrical outlet
before adjusting tool or installing
accessories.
Work Piece and Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must
not allow access by children or pets
to prevent distraction and injury.
2. Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to
allow free movement while working.
3. Secure loose work pieces using
a vise or clamps (not included) to
prevent movement while working.
4. There must not be objects, such
as utility lines, nearby that will
present a hazard while working.
Mounting Tool Bits and
Locking Side Handle
1.
WARNING!
Before installing new bit,
verify Demolition Hammer is unplugged.
2. Pull out and turn Locking Lever (73A)
either clockwise or counterclockwise.
3. Insert the shank portion of the
chisel 1″ into the Retainer (70A).
4. Slide Locking Lever back into Retainer.
5. Pull chisel to verify it is secure.
6. The Side Handle (91) can be loosened
and readjusted to be either above or
under housing. To adjust its position,
loosen the Hex Bolt (93A) and slide
the Side Handle to desired position.
Retighten the Hex Bolt until the Side
Handle is fastened securely into place.
General Operating Instructions
1. Once the chisel is installed and the Side
Handle set in the desired position, set
the tip of the bit against the work area.
2. Place one hand on the Side
Handle and the other hand around
the Main Handle (80A).
3. Press the Trigger Switch (79D) to
activate the Demolition Hammer.
4.
WARNING!
Once activated, do not
press, bear down or thrust forcibly
against the work surface. Hold the
Demolition Hammer with just enough
pressure so that the tool’s own
weight supplies the needed force.
5.
NOTE:
If the Demolition Hammer has
not been used for a long period of time
or is being used in low temperatures,
keep the tool running for about five
minutes to allow for warm-up. Make
sure the Trigger Switch properly
actuates when pressed and that the
tool turns off when its released.
6. When work is complete,
release the Trigger Switch.
