Central Machinery 66435, Руководство по установке и эксплуатации, Страница: 9 / 29

SKU 66435 For technical questions, please call 1-800-444-3353. Page 9
indicate it is acceptable for outdoor
use.
Make sure the extension cord is prop-
7.
erly wired and in good electrical con-
dition. Always replace a damaged
extension cord or have it repaired by
a qualified electrician before using it.
Protect the extension cords from 8.
sharp objects, excessive heat, and
damp or wet areas.
rECOMMENDED MINIMUM WIrE
GAUGE FOr ExTENSION COrDS*
(120/240 VOLT)
NAMEpLATE
AMpErES
(at full load)
ExTENSION COrD
LENGTH
25’ 50’ 75’
100’ 150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
TABLE A
* Based on limiting the line
voltage drop to five volts at
150% of the rated amperes.
SYMBOLOGY
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
n0 xxxx/min.
No Load Revolutions per Minute
(RPM)
SpECIFICATIONS
Electrical
Requirements
120 V~ / 60 Hz
550 Watts / 2.25 Amps (No Load)
Motor Type: Single Phase, Fan Cooled
Motor HP: 1/3
Motor RPM: 1725
Power Switch Type: Toggle Switch
Power Cord: 18 AWG x 3C
Power Plug: 3-Prong, Grounded
Cutting
Capacity
4-1/8” Round Stock
4” x 6” Rectangular Stock
Variable Speed
Capacity
Position #1: 80 FPM
Position #2: 122 FPM
Position #3: 180 FPM
V-Belt Type 3V-270
Saw Blade Size 1/2” x .025” x 64-1/2” (14 TPI)
UNpACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
ASSEMBLY INSTrUCTIONS
read the ENTIrE IMpOrTANT
SAFETY INFOrMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO prEVENT
SErIOUS INjUrY
FrOM ACCIDENTAL
OpErATION:
Turn the power Switch of the
Bandsaw to its “OFF” position
and unplug the Bandsaw from
its electrical outlet before
assembling or making any
adjustments to the tool.