Page 8
For technical questions, please call 1-888-866-5797.
Item 63995
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Operating instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
inspect tool before use, looking for damaged, loose, and missing parts. if any problems
are found, do not use tool until repaired. Wear anSi-approved safety goggles,
heavy-duty work gloves, and steel-toe work boots during set up and/or use.
Bleeding the ram
iMpOrtant!
Before first use, check for proper
hydraulic fluid level in the Ram. Then thoroughly
test the Ram for proper operation prior to its
actual use. If the Ram appears
not
to be working
properly, it may be necessary to
bleed
its hydraulic
system of excess air. To bleed the Ram:
1. Remove the Fill Plug.
2. Place the slot on the Ram Handle
over the Release Valve.
3. Turn the Ram Handle
counterclockwise
to open the Release Valve.
4. Insert the Ram Handle into the Fulcrum, then
pump the Ram Handle quickly several times.
5. Check the Fill Hole and, if necessary,
top off with hydraulic fluid.
6. Place the slot on the Ram Handle
over the Release Valve Screw.
7. Turn the Ram Handle
clockwise
to
close the Release Valve.
8. Replace the Fill Plug.
9. Test the Ram several times before putting into use.
General Operating instructions
1. Adjust the Press Apron height as necessary.
note:
The Press Apron should be in the
highest position possible with the workpiece
as close as possible to the Press Pin.
2. Place the workpiece on the Arbor Plates.
Adjust the Arbor Plates to support the
stationary part of the workpiece.
WarninG!
Keep area under Arbor Plates
clear. If Arbor Plates rest on obstruction
(i.e., bolt, debris, etc.), it creates an uneven press,
causing excess stress and possible breakage.
WarninG!
When pressing two items together,
the items must be lined up vertically. If not, one
may forcefully eject itself sideways from the unit.
3. Close the Release Valve.
4. Pump the Ram Handle until Press Pin
contacts the workpiece. Continue to pump
the Ram Handle to press the workpiece.
5. After work is completed, be careful when
releasing Jack pressure.
Slowly
open the
Release Valve, allowing the Ram Plate to rise.
6. WARNING! During the release process the
Ram may rise quickly. Stay clear.
7. Store Shop Press out of reach of children.
WarninG!
Before use, inspect the position of
the Press Apron Support Pins (7) to be sure they
are centered before and during operation.