Page 5
For technical questions, please call 1-888-866-5797.
Item 63995
SaFEty
OpEra
tiOn
MaintEnancE
SEtup
assembly instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Wear anSi-approved safety goggles, heavy-duty work gloves,
and steel-toe work boots during set up and/or use.
note:
Finger tighten all connections until assembly
is done. unless directed otherwise, do not fully
tighten the fasteners until ready to align the
assembled press.
assemble on a flat, level, hard surface.
use a helper when necessary.
1. Attach Back (6) and Front (11) Frames to Foot (3)
with two sets of Bolts (1), Washers (2), and Nuts (4).
note:
Make sure holes align on Back and Front Frames.
2. Repeat for the other Frames and Foot.
Back
Frame (6)
Front
Frame (11)
Bolts
(1)
Washers (2)
nuts
(4)
Foot (3)
Figure B
3. Attach Spreader (5) to front and back of
Frame/Foot assembly with two Bolts (1),
Washers (2), and Nuts (4).
4. Repeat to attach other Frame/Foot assembly
to the other end of the Spreader (5).
Figure c
5. Slide Press Apron (15) over Foot/Frame assemblies
and secure with Press Apron Support Pins (7).
WarninG! Support pins must be centered.
press
apron (15)
press apron
Support pins (7)
Figure D
6. Attach lower Press Pin Guide (18) to
Bottom Cross Beam (16) with two Bolts (1),
Washers (2), and Nuts (4). Tighten securely.
press pin
Guide (18)
Bolts (1)
Bottom cross
Beam (16)
Figure E
7. Attach upper Press Pin Guide (18) to
Top Cross Beam (17) with two Bolts (1),
Washers (2), and Nuts (4). Tighten securely.
Bolts
(1)
top cross
Beam (17)
Figure F
Washers (2),
nuts (4)
Spreader
(5)
Bolt
(1)
Bolt
(1)
