Page 8
SKU 45656
For technical questions, please call 1-800-444-3353.
OpERATING INSTRUCTIONS
NOTE: All parts below refer to the parts listed on pages 17 through 22 of this
manual.
To Perform Preliminary Operating Tests:
Connect the Tire Changer to its air and electrical supply sources, and allow
1.
adequate time for the compressed air system to reach the recommended 110
PSI.
(See Figures A, C, D, and E.)
When the Reverse Pedal (59E) is fully depressed, the Turntable (1C) should turn
2.
in a
clockwise
direction.
(See Figures B and E.)
When the Reverse Pedal (59E) is raised, the Turntable (1C) should turn in a
3.
counterclockwise
direction.
Press the Bead Breaker Pedal (26E) to activate the Paddle (7B). When the
4.
Pedal is released, the Paddle should return to its original position.
Press the Jaw Clamp Pedal (26E) once to open the four Jaws (17C). Press the
5.
Pedal again to close the Jaws.
LOCKING
LEVER
NOZZLE
AIR GAUGE
(#4F)
TRIGGER
FIGURE G
6.
Press the Trigger on the Air Gauge (4F) to release air from the Nozzle.
(See
Figure G.)
To Break The Tire Bead:
1.
WARNING:
Before carrying out this procedure, deflate the tire fully, and remove
all the wheel weights.
2.
Position the wheel against the rubber Buffers (39B) located on the front/left side
of the Tire Changer.
(See Figure E and Assy. Diagram B.)
3.
Position the Paddle (7B) against the tire bead at a distance of about 1/2” from the
tire rim.
(See Figures E and H.)
REV 05/05
