Page 13 SKU # 42827
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS
A REFERENCE TOOL ONLY: NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTA-
TION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY RE-
PAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT:
IN FACT THE MANUFACTURER A ND/OR DISTRIBUTOR EXPRESSLY STATES THATALL REPAIRS AND
PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT
BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO
THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTAL-
LATION OF REPLACEMENT PARTS THERETO.
MAINTENANCE
After each use:
1.
Turn off the power switch and unplug the machine from its power source.
2.
Remove any tool bits, clean and lubricate them, and return them to their storage case.
3.
Using a stiff bristle brush, brush off all chips and shavings left from the machining operation.
4.
Using a rag, wipe off any excess or dirty oil or cutting fluid left on the machine.
5.
Lubricate the points indicated in
Figure 2
. Apply light grease or oil to all unpainted metal to prevent
corrosion.
6.
Cover the machine to prevent dust or dirt contamination when not in use.
Daily Maintenance:
1.
Fill the oil reservoir to the proper level before each use.
2.
Check the tightness of the bolts holding the head in place.
3.
If overheating is observed, or unusual noises are produced, stop the machine immediately to check for
lack of lubrication, faulty adjustments, dull tool bits, or other deficiencies. Correct any problems before
resuming work.
4.
Keep the work area clean. If chips or shavings accumulate on the table or fixtures, shut off the power
and clean the chips away with a stiff bristle brush. Re-check the lubrication before continuing.
Weekly Maintenance:
1.
Clean and coat the lead screw with oil.
2.
Check the lubrication of the sliding parts of the table. Apply light grease if needed.
Monthly Maintenance:
1.
Adjust the accuracy of the slides on both the cross and longitudinal feeds.
2.
Lubricate the bearings, worm gear and worm shaft with light grease.
Yearly Maintenance:
1.
Adjust the table to assure that it is level in all directions.
2.
Check the electrical cord, plug, circuit breakers and related connections to assure that they are secure
and safe.
3.
Drain the lubricant from the gear box and replace it with heavy grade motor oil.
NOTE: Some parts on the following pages are listed and shown for illustration
purposes only and are not available individually as replacement parts.
