SKU 04223
PAGE 5
7.
ALWAYS KEEP HANDS AND FINGERS AS FAR AWAY FROM THE CUTTING
BLADES (part #22) AS POSSIBLE.
8.
ALWAYS STAND OFF TO ONE SIDE OF THE BENCH TOP PLANER.
9.
DO NOT REACH ACROSS THE BENCH TOP PLANER WHEN IT IS ON.
10.
MAKE SURE TO FEED THE WORKPIECE INTO THE CUTTING BLADES
(part #22), AND AGAINST THE ROTATION OF THE BLADES.
11.
PLANE ONLY WOOD BOARDS.
12.
DO NOT FORCE FEED THE WORKPIECE THROUGH THE BENCH TOP
PLANER.
Allow the Bench Top Planer to feed at the designated rate of feed.
13.
DO NOT ATTEMPT TO CUT DEEPER THAN 1/8” OR PLANE MATERIAL
SHORTER THAN 15” LENGTH.
14.
WHEN FEEDING THE WORKPIECE INTO THE BENCH TOP PLANER, USE A
PUSH BLOCK (not included) RATHER THAN USING YOUR HANDS.
The
Push Block must be thinner than three inches.
15.
BEFORE PLANING ANY WORKPIECE, CHECK FOR ANY FOREIGN MATERI-
ALS SUCH AS NAILS, SCREWS, OR HARD IMPURITIES IN THE WOOD.
Also
check for loose knots in the workpiece.
16.
AFTER EACH PLANING, USE THE ROLLERS (part #7) ON TOP OF THE
BENCH TOP PLANER TO ROLL THE WORKPIECE BACK TO THE FEED
POSITION, RATHER THAN CARRYING THE WORKPIECE BACK AND
FORTH.
17.
ALLOW THE SAW BLADES (part #22) TO TURN UP TO FULL SPEED BE-
FORE FEEDING A WORKPIECE INTO THE BLADES.
When turning off the
Bench Top Planer, allow the Blades to slow down and stop on their own. Do not
press against the Blades to stop them.
18.
WHEN CUTTING A LARGE WORKPIECE, MAKE SURE ITS ENTIRE LENGTH
IS PROPERLY SUPPORTED.
If necessary, use a roller stand (not included) with
a larger workpiece.
19.
NEVER ATTEMPT TO REMOVE MATERIAL STUCK IN THE MOVING PARTS
OF THE BENCH TOP PLANER WHILE IT IS PLUGGED IN AND RUNNING.
20.
TURN OFF THE BENCH TOP PLANER IF THE WORKPIECE IS TO BE
BACKED OUT OF AN UNCOMPLETED CUT.