SKU 04223
PAGE 11
the Cutterhead (part #20) and carefully rotate the Cutterhead until it locks in
position.
(See Figure E.)
11.
Repeat Steps #4 through #9 for the second Blade (part #22).
(See Figure E.)
12.
Replace the Chip Deflector (part #18), and secure it in place with the two Screws
(part #19).
(See Figure E.)
OPERATING INSTRUCTIONS
NOTE:
If necessary, refer to
page 10
for
additiona
l operating instructions.
1.
CAUTION: Prior to performing any adjustments, make sure the Power
Switch (part #21A*) is in its “OFF” position and that the Power Cord (part
#22A*) is unplugged from its electrical power outlet. (See Figure D.)
2.
Lift up on the Head Lock Lever Assembly (part #52). Then turn the Handle
Assembly (part #11)
clockwise
to raise the depth or
counterclockwise
to lower the
depth to the desired setting as indicated by the Pointer (part #86) and Ruler.
(See Figure F.)
3.
After adjusting the planing depth, make sure to lower the Head Lock Assembly
(part #52) to lock the desired setting in position.
(See Figure F.)
4.
Preset the planing depth if necessary, using the Thickness Gauge (part #79).
(See Figure F.)
THICKNESS GAUGE
(#79)
HEAD LOCK ASSY.
(#52)
HANDLE ASSY.
(#11)
POINTER
(#86)
RULER
ROLLER (#7)
STOCK REMOVAL
INDICATOR ASSY.
(#81)
POWER SWITCH
(#21A*)
FIGURE F