Clamp Meter
2
1.
SAFETY INFORMATION
1.
Do not operate the tester if there is any sign of damage to the
tester or the test leads.
2.
Check the main function dial and make sure it is in the correct
position before each measurement.
3.
Do not perform resistance and continuity tests on a live power
system.
4.
Do not apply voltage between the test terminals and test
terminal to ground that exceed the maximum limits stated in this
manual.
5.
Keep your fingers behind the protection ring on the test probes
when using the test leads.
6.
Change the battery when the
symbol appears to avoid
incorrect data.
Environmental Conditions
Operation Temperature: 0°C to 40°C (32°F to 104°F); < 80 % RH
Storage Temperature: -10°C to 60°C (14°F to 140°F
);
< 80 % RH
Explanation of Symbols
Attention refer to operating instructions.
Dangerous voltage may be present at the terminals.
This instrument is double insulated.
Approvals:
EN61010 300V CAT-IV
2. GENERAL SPECIFICATION
Digital Display:
4 digit liquid crystal (LCD), Maximum reading 6,000 counts.
Polarity:
When a negative signal is applied, the
“
” sign appears.
Low Battery Indication:
When the battery voltage is below that required for proper operation
then the
symbol
will appear on the LCD display.
Sample Rate:
2 times/sec for digital data.
