12
SECTION 5
DRIVING PROCEDURES IN UNUSUAL CONDITIONS
5.6 AMPHIBIOUS OPERATION - GENERAL
The CENTAUR may sink if filled with water. If water
starts entering the vehicle, head to the nearest shore
immediately. Be prepared to abandon the vehicle if it
appears that the vehicle will fill with water before you
reach the shore. Be especially cautious when operating
a loaded vehicle (cargo and/or passengers) in water.
Observe the capacity limits.
Centaur vehicles are self-propelled, amphibious vehicles, ca-
pable of navigating calm water, provided the following pre-
cautions are observed:
1.
Do not enter water if the vehicle is overloaded. Refer to
Section 1.4 of this manual for recommended load capac-
ity in water.
2.
Do not use seat belts or any passenger restraining device
while operating the Centaur in water. If an emergency
arises, you and your passengers may have to leave the
vehicle quickly.
3.
Do not attempt to cross large bodies of water. Stay close
to the shore in case an emergency arises and you have to
leave the water.
4.
Do not attempt to navigate any body of water with a strong
current. Avoid water operation under windy conditions.
5.
Use extra caution when operating the Centaur in cold
water. If the vehicle upsets or swamps, exposure in cold
water significantly reduces the chance of survival.
6.
Be prepared to adjust the position of cargo and passen-
gers so the vehicle floats level.
7.
Care must be taken when encountering submerged ob-
stacles that may upset the vehicle.
Observe the following safety precautions BEFORE entering
the water:
1.
All occupants must wear an approved personal flotation
device (PFD) or life jacket while traveling in water.
2.
Equip the vehicle with a paddle and bailing can. Optional
bilge pump kits (Part No. 849-146) are available from
your Centaur dealer and are recommended for water op-
eration.
3.
Make sure both drain plugs in the rear of the lower body
(Figure 5-1) are in place and properly tightened. To in-
stall, locate the drain plugs at the rear of the vehicle and
thread each drain plug in a clockwise direction into the
plug fitting ensuring a snug fit. Check the O-ring on drain
plug periodically. When removed, each drain plug re-
mains attached to the hole opening to prevent loss or
misplacement of the plug while the vehicle is draining.
(Figure 5-2).
Figure 5-1. Location of the drain plugs.
Figure 5-2. Removing and installing the drain plugs.
4.
Visually check the lower body of the vehicle for cuts,
punctures or holes that will allow water to enter the vehi-
cle.
5.
Make sure that any cargo in the rear of the vehicle is
evenly distributed.
6.
Periodically inspect the fit of the axle housings to the
lower body to ensure they are water tight. If there are
signs of water leaking into the lower body, take correc-
tive action before entering water again.
Always observe the recognized rules of boating while
traveling in water.
Содержание amphibious, off-road utility vehicle
Страница 54: ...46 NOTES ...
