Page 14
is less than 11V or greater than 13V DC, the
power supply will need to be replaced.
Intermittent laser
The power supply is not stable
Use a voltmeter to check power the supply.
Replace the unstable power supply.
4
Maintenance
4.1 Repair
WARNING
– Only certified Cemar Electro Inc. technicians should carry out any repairs to your
laser units other than changing the laser module (
Note: Changing the laser module will require an
adjustment of the 90-degree cross projection
). Without written permission of Cemar Electro Inc.,
any unauthorized repairs to the laser unit can cause further damages and will result in the Cemar
Electro Inc. warranty becoming null and void. Before any service can be done the unit must be
switched off and the power must be disconnected from the supply using the appliance inlet.
WARNING
–No modifications may be made to the remote control as this will result in the Cemar
Electro Inc. warranty becoming null and void.
4.2 Maintenance, Cleaning, and Disposal
Once the MAXX-700 laser unit is installed,
CEMARLINE
lasers require no maintenance other
than cleaning beam splitters and lenses according to standard optical practices.
•
Occasional outside dusting of the antireflective window in the cover may be necessary.
Use only fiber optic splice and connector cleaner with clean wipes.
•
Clean other outside surfaces of the laser unit with a soft cloth slightly moistened with water
or a mild detergent solution and then wipe the surface with a dry cloth.
•
Do not use any type of abrasive pad, scouring powder, or chemical solvent such as thinner,
benzene, alcohol or disposable wipes as these may damage the finish.
