INSTALLATION INSTRUCTIONS
1.The unit may be mounted either between joists using the inbuilt clip fasteners or against a
joist using a screw through the flange plate. The approximate cut-out size of the unit is 295 x
295mm.
Please note this is only an approximate measurement and any installation would
require a measurement against the physical product to ensure the best fit.
Mark the
ceiling with a pencil showing the area of ceiling to be cut.
IMPORTANT NOTE: Celsius takes no responsibility for those instances where the physical
product is not measured first before the hole is cut in the ceiling.
2.Before commencing cutting ensure that the area behind the intended location is clear of all
cables, pipes and joists. Once clear, cut out the section along the previously marked lines.
3.Remove the lamps from the housing by unscrewing them anticlockwise. Then remove the
decorative fascia from the housing by removing the spring clips that hold it in place.
4.Insert the unit into the hole being sure to pull the side springs inward so that the body can
pass through the hole without damaging the plaster. Ensure that the unit is held securely in
place by clips. It is essential that additional screws (not supplied) are used to aid holding the
unit in the ceiling. Screw holes are provided in the flange for this purpose. 2 strips of timber
(one on each side) should be placed behind the holes inside the ceiling to give the screws
something to anchor to and to provide some reinforcing. Do not secure the unit at this time.
5.Remove the unit from the ceiling and connect the wiring to the terminal block as per the wiring
diagram. This terminal block is on one corner of the back of the unit.
6.Insert the unit into the hole and secure as detailed in point 4 above.
7.1x white and 1x silver fascia are included with this product. Choose only one of these fascia
colours to install. Hold the fascia against the body of the appliance and the ceiling, then attach
the securing spring clips to hold the fascia in place.
8.Now screw in the 275W heat lamps provided into the lamp holder through the holes provided
in the fascia. The globes should be screwed in firmly to ensure a good electrical contact but
don’t over tighten. Fit the small centre light bulb in the same way ensuring that it is positioned
centrally.
IMPORTANT NOTE: Over tightening of heat lamps or light bulbs may result in damages to the
lamp holders or lamps, take care when removing and replacing heat lamps/bulbs
HEAT/LIGHT/VENT INSTRUCTIONS
