WALL-MOUNTED ELECTRIC FIREPLACE/HEATER
BFM EUROPE LTD Page 11
Remote Control Button Function
Remove the battery cover on the back of the handset by sliding downwards and insert 2 x AAA batteries
ensuring that the batteries are fitted correctly. Refit the battery cover.
Ensure that the ON / OFF Power Switch on the fire is in the ON position.
OPERATING INSTRUCTION WITH REMOTE CONTROL
Point the remote control handset directly towards the fire and press the appropriate button to operate the
fire. The fire will respond with a beep to accept the new programmed setting. The handset has a
memory function which will restart the fire with the last settings except for the Sleep timer function which
will always reset to OFF.
POWER
The Power button turns the appliance ON or OFF.
MODE
The mode button is used to cycle through the 3 available setting
modes – Flame , sleep timer , heat .
FLAME
When the flame icon is selected, the flame segment icon will
blink for 5 seconds. During this period the flame settings can be
changed using the
or
buttons to select the available
brightness settings (
High
,
Med
,
Low
,
Dynamic) or
OFF. If no buttons are pressed within 5 seconds the flame
segment icon will stop blinking and the flame brightness will be set
to memory. To change the flame setting again press the mode
button
again which will blink the flame segment icon allowing
the flame setting to be changed.
SLEEP TIMER
When the timer icon is selected, the 00 icon will blink, pressing
the
or
buttons within 5 seconds will adjust the sleep timer
range from 1-8 hours. If no buttons are pressed within 5 seconds
the timer icon will stop blinking and the timer will be set to
memory. To change the timer again press the cycle button
which will blink the timer icon allowing the duration to be changed.
To switch off the timer function set this to 00.
