Cellularline Interphone EDGE, Руководство пользователя

Страница: 5 / 13

ENGLISH - 9 ENGLISH - 10
If you select a wrong language, follow the steps below:
1. Turn off the EDGE. (Press the MFB for 5s, or until the led lights RED).
2. Turn on the EDGE (Press the MFB for 2s).
3. Short press UP button (2).
4. Short press MFB button (1).
5. Short press UP button (2).
6. Press MFB when you hear your language.
2.6 Audio priorities
EDGE determinates the audio source priority in the following way:
1. Mobile phone
2. Intercom
3. A2DP audio (Smartphone/Player MP3)
4. FM Radio
Example:
● Incoming mobile call interrupt ongoing A2DP music.
● Incoming Intercom call does not interrupt an ongoing mobile phone call; the rider,
who started the intercom call, will hear a “connection failed” message.
2.2 Status led (Pic.2)
Standby BLUE led (6) flashes every 3 seconds.
Intercom active BLUE led (6) is solid.
Interphone connected with
mobile/GPS
BLUE led (6) flashes twice every 3 seconds.
Pairing mode BLUE (6) and RED (6) led flash alternately.
Charging
ORANGE led (6) is solid. When charging is completed
led (6) becomes solid GREEN.
Battery low Led (6) is solid RED.
2.3 First Switch on (only twin pack)
Press MFB (1) button to turn on both units. The units are already factory-
paired, wait for your language and press MFB (1) button to confirm.
Later two units will be in “INTERCOM” Standby status (Chapter 4).
2.4 First Switch on (only single pack)
Press MFB (1) button to turn on unit.
The unit will enter in “PAIRING MODE”, choose one of these:
- Pairing with mobile phone or GPS navigator.
- Short press of Up (2) button – intercom pairing with INTERPHONE device.
- Short press of DOWN (3) button – intercom pairing with other brand device(NON
INTERPHONE) ANYCOM mode.
- Long press of MFB (1) until the beep – to cancel “PAIRING MODE”. Unit will enter in
“INTERCOM” Standby status(Chapter 4) and Blue led (6) will flash every 3 seconds.
2.5 Language selection (after first switch on):
EDGE in Standby mode (Blue led(6) flashing), press UP button(2) and then MFB button(1)
to enter in “SETUP” menu. Press again UP button(2), “LANGUAGE SELECTION” start,
wait for your language and then press MFB button (1)to confirm it.