CelloTrack T Installation Guide
CelloTrack T Installation Guide
Page 12 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
Set Of Star Keys
Set Of Allen Keys
Regular Pliers
Needle-Nose Pliers
3.3
Initial Setup for the CelloTrack
To setup the CelloTrack unit, perform the following steps:
------------------------------------------------------------------------------------------------
NOTE:
The unit set up should be conducted under lab conditions.
------------------------------------------------------------------------------------------------
1.
Loosen the eight screws and remove the back cover of the CelloTrack unit.
------------------------------------------------------------------------------------------------
NOTE:
Make sure the SIM card is not PIN protected.
------------------------------------------------------------------------------------------------
2.
Prepare the SIM card. If the SIM is PIN protected, insert it into a cell phone and
disable the PIN code.
3.
Gently slide the SIM card into the SIM holder.
4.
Verify that the rubber seal (O-ring) is securely in place.
5.
Close the unit and make sure not to damage the battery wires while closing it.
6.
Insert the eight screws. First, tighten the central screws and then the other screws.
Tighten screws to a torque of 4 kgf-cm (kilogram force per centimeter) which is
approximately 0.4 Nm (Newton per Meter).
7.
Verify the unit is operating correctly by pressing the FB of the unit and validating that
the SYSLED blinks (1 sec on / 1 sec off).
3.3.1
Charging the Unit Battery
The unit’s battery must be charged with the provided charger before usage.
1.
Plug the charger into an electricity outlet (100V/60Hz or 220V/50Hz).
2.
Remove the connector cover
