10
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
t
t
h
h
e
e
F
F
i
i
n
n
d
d
e
e
r
r
s
s
c
c
o
o
p
p
e
e
To install the finderscope:
1.
Locate the finderscope (it will be mounted inside the finderscope bracket)
– see Figures 1-1 and 1-2.
2.
Remove the knurled nuts on the threaded posts on the optical tube – see
Figure 2-17.
3.
Mount the finderscope bracket by placing it over the posts protruding
from the optical tube and then holding it in place thread on the knurled
nuts and tightening them down.
4.
Note that the finderscope should be oriented so that the larger diameter
lens is facing toward the front of the optical tube.
5.
Remove the lens caps from both ends of the finderscope.
A
A
l
l
i
i
g
g
n
n
i
i
n
n
g
g
t
t
h
h
e
e
F
F
i
i
n
n
d
d
e
e
r
r
s
s
c
c
o
o
p
p
e
e
Use the following steps to align the finderscope:
1.
Locate a distant daytime object and center it in a low power (20mm) eyepiece in the main telescope.
2.
Look through the finderscope (the eyepiece end of the finderscope) and take notice of the position of the
same object.
3.
Without moving the main telescope, turn the adjustment thumb screws located around the finderscope
bracket until the crosshairs of the finderscope are centered on the object chosen with the main telescope.
Figure 2-18 Finderscope with Bracket
Objective Lens
Finderscope Bracket
Eyepiece
Adjustment Screws
Figure 2-17
