ENGLISH
I
3
alarm setting
• Press “MODE” button to navigate to Alarm Time Display (“AL”
icon displays on the LCD). Hold “MODE” button for 3 seconds
to enter alarm clock setting mode. Press “
▼
” or “
▲
” to change
setting, and press “MODE” button to confirm and move to next
setting.
• The setting sequence is: Hour, Minute and Alarm ON
(
)/OFF (
).
• When the alarm is on, the symbol “
” appears and when it is
off the symbol “
” disappears.
• When alarm goes off “
” will flash. Press any button (except
SNOOZE/LIGHT button) to stop the alarm. If no button is
pressed the alarm will automatically stop after 2 minutes.
• When alarm is going off, press “SNOOZE / LIGHT” button to
activate the snooze alarm, (Zzz icon will flash on screen). The
alarm will snooze for 5 minutes. The snooze function can be
used only 7 times.
Dual time setting
• Press “MODE” button until “DT” is shown on the screen.
• Hold “MODE” button for 3 seconds to enter Dual Time setting.
the “Hour” digits flash. Press “
▲
”or “
▼
“ button to adjust the
“hour”, press “MODE” button to confirm and quit the setting.
coMpass
The compass shows the bearing in degrees due North together
with 16 cardinal points.
• Press the Compass button and the unit will enter the
Compass mode. Make sure to hold the unit horizontally,
parallel to the ground. Point the arrow that is printed on the
Compass housing in the direction you wish to travel. This
direction will be displayed along with the angle in ° (degrees).
the lcd arrow {
▲
} will always point north.
• If no key is pressed for 30 seconds, the unit will automatically
shut off the compass and return to the temperature mode.
Note: The compass must be kept in a level position when in use. Taking a measurement
while the unit is not horizontal (in relation to the horizon) can result in a large
measurement error.
Always take bearings in the open air, because it is easily affected by disturbing sources
of magnetism.
For detailed calibration steps, see complete manual online at www.celestron.com
