English
- 15 -
Press the
GREEN
button to switch to advanced
mode and then press the
OK
button to edit settings.
This means that the connection is now established.
To disconnect from a wireless network, you should
highlight
&RQ¿JXUDWLRQ6WDWXV
and press
OK
.
You can navigate between menu tabs by pressing
left/right buttons. The help bar on the bottom of the
dialog shows features that you may use. Press the
BLUE
button to check your internet connection speed.
You can check the signal strength by using the network
settings menu for the wireless device mode.
Other Information
Configuration Status
: Displays Wi-Fi status as
connected or not connected.
IP Address
: Displays the current IP address.
Network Name
: Connected networks’ name will be
displayed.
'HOHWH6DYHG:L)L3UR¿OHV
6DYHGSUR¿OHVZLOOEHGHOHWHGLI\RXSUHVVWKH5HG
button while the wireless device selection OSD is
on the screen.
Connecting to your mobile Phone via WiFi
If your mobile phone has WiFi feature, you can
connect your mobile phone to your TV by using
a WiFi connection via a router, in order to play
content from your phone. For this, your cell phone
must have appropriate sharing software.
Connect to your router following the steps stated
above in the Wireless Connection section.
Afterwards, engage your cell phone with the router
and then activate the sharing software on your cell
SKRQH7KHQVHOHFW¿OHVWKDW\RXZRXOGOLNHWRVKDUH
with your TV.
If the connection is established correctly, you should
QRZEHDEOHWRDFFHVVWKHVKDUHG¿OHVIURP\RXUFHOO
phone via the Media Browser of your TV.
Enter the Media Browser menu and the playback
device selection OSD will be displayed. Select your
mobile phone and press the
OK
button to continue.
Note:
This feature may not be supported on all mobile
phones.
The location where the transmission is most effective
differs depending on the usage environment.
The Wireless LAN adaptor should be connected directly
to the TV’s USB port. USB hubs are not supported.
7R FRQ¿JXUH ZLUHOHVV VHWWLQJV SOHDVH UHIHU WR WKH
WiFi section in the Settings menu.
Wireless LAN adaptor supports 802.11 a,b,g &
n type modems. It is highly recommended that
you should use the IEEE 802.11n communication
protocol in order to avoid any possible problems
while watching videos.
Use the other USB input, if you experience problems
with audio/video performance.
You must change your modem’s SSID when there are
any other modems around with the same SSID. You
can encounter connection problems otherwise. Use
a wired connection if you experience problems with a
wireless connection.
To enable Wi-Fi features, plug in the Wi-Fi dongle to
one of the USB ports.
Press the
YELLOW
button to scan the wireless
networks from the network settings menu. A list of
available networks will be displayed. Please select
your desired network from the list.
Note:
If the modem supports N mode, you should set N
mode settings.
If the selected network is protected with a password,
please enter the correct key by using the virtual
keyboard. You can use this keyboard via the
navigation buttons
(“ ” or “ ” , “ ” or “ ”) and the
OK
button on the remote control.
Wait until the IP address is shown on the screen.
