7
Ceiec Electric Technology
2.3 Mounting
The PMC-1302 ESG should be installed in a dry environment with no dust and kept away from heat,
radiation and electrical noise sources.
Installation steps:
Wall Mounting
Pre-drill four mounting holes on the back plate according to the diagram below.
Remove the two mounting plates (top and bottom) from the back of the PMC-1302 ESG by first
removing the screws that fix the mounting plates in place.
Re-position the mounting plates by sliding the top plate upward and the bottom plate downward
such that the area with the mounting holes protrude from the device's body and re-install the
screws that hold the mounting plates in place.
The PMC-1302 ESG package comes with four additional mounting screws in a little plastic bag.
Use these screws to mount the PMC-1302 ESG on to the back plate.
A Philips screw driver with a long shaft will ease the mounting process.
Figure 2-3-1 Wall Mounting
DIN-Rail Mounting
Before installation, make sure that the DIN rail is already in place
Align the top of the mounting clip at the back of the PMC-1302 ESG at an angle against the top of
the DIN rail as shown in the figure below
Rotate the bottom of the PMC-1302 ESG towards the back while applying a slight pressure to
make sure that the mounting clip is completely and securely fixed on to the DIN rail
