Issue 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
9
TESTING/OPERATION CONTINUED…
4.03 If no PBX access code or number was programmed, the auto-dial number
will automatically dial out by itself. When the called party answers, the LED
will turn GREEN after a maximum of four seconds, provided that the ADA
feature was activated during programming (see programming section 3.07, Digit
6). After the called party answers, a normal speakerphone conversation should
be allowed. If the auto-dial number does not work, please repeat sections 3.02,
3.03, 3.04, 3.07, 3.08, and 3.10 only. If trouble is still experienced, please refer
to section 11.02.
4.04 When the call is complete, press the “CALL” button again to hang up the phone.
The call will be terminated and the LED will go out. If an automatic call
disconnect was programmed, allow the conversation to continue past the set
time (1-9 minutes). Once the time limit expires, the phone will automatically
disconnect the call. A three-tone error signal will be heard as the call is
disconnected. The time is not exact. If the automatic call disconnect feature
does not work properly, please repeat sections 3.02, 3.03, 3.04, 3.08, and 3.10
only. If trouble is still experienced, please refer to section 11.02.
4.05 If the phone was programmed to allow incoming calls, place a call into the
phone. When the phone rings, press the “CALL” button. The microphone
should activate approximately three seconds after the call is answered and a
normal speakerphone conversation should follow. If the phone was
programmed not to allow incoming calls, the microphone will not turn on. If
this does not work, please repeat sections 3.02, 3.03, 3.04, 3.08, and 3.10 only.
If trouble is still experienced, please refer to section 11.02.
4.06 Testing is now complete. If any trouble was encountered that has not been
remedied, please refer to section 11.02 of this manual, otherwise the phone is
ready for operation.
NOTE:
CEECO can not be responsible for the called party's response regarding
ADA features and compliance, and emergency response.
4.07 Carefully return the telephone assembly to the weatherproof housing. Secure it
in place using the four (4) security screws and security tool. If the telephone has
not yet been installed at its intended location, please refer to section 7.0, before
performing this step.