Cedes TOFniva, Инструкция по установке и эксплуатации

Страница: 5 / 12

TOFniva English
© CEDES | V 1.2 5
Important:
The scale is not printed on the sensor. The
potentiometer can be adjusted linear from of 0.4 m to
2.0 m; see Figure 3 below.
Take a small screw driver and turn the potentiometer
to the required position.
Figure 3: A type: Detection field using potentiometer
Figure 4: C type: Detection field using potentiometer
Table 1: Parameter - detection field
6. Installation
1. Switch off main power to the control unit and mark
clearly that this system is out of service before
performing any work on the system.
2. Define the ideal place to mount the sensor
Important: The TOFniva must be mounted with a 6°
angle or with a minimum distance of 200 mm parallel
to Surface B.
3. Cut a hole at the defined position into Surface A.
For the use of the flush mounting use the delivered
drilling pattern or use a surface mounting kit. More
details about available surface mounting kit are
written in the accessories sheet of the TOFniva.
85
70.5
57
4.8
Cut-out for
flush mounting
4.8
40
34
Important: The angle type has to be mounted at a
45° angle to the detection area. The centre type can be
mounted flat (0°).
45°
4. Place the sensor and connect it according connecting
diagram in Chapter 7.
5. Switch on mains and power-up the control unit.
6. Adjust the detection field.
7. Test if the system is working correctly.
90°
x = min. 400 ... max. 2000
y = min. 400 ... max. 2000
2 m
1.2 m
0.4 m
0.8 m
1.6 m
2 m
1.2 m
0.4 m
0.8 m
1.6 m
x-axis
y-axis
IMPORTANT
The cable exit of the sensor
is always at the bottom
2 m
1.2 m
0.4 m
0.8 m
1.6 m
2 m
1.2 m
0.4 m
0.8 m
1.6 m
x-axis
y-axis
x = min. 400 ... max. 2000
y = min. 400 ... max. 2000
90°
Parameter Value
Operating range
x-axis Min.: 0 ... 400 mm
Max.: 0 ... 2,000 mm
Operating range
y-axis Min.: 0 ... 400 mm
Max.: 0 ... 2,000 mm
Aperture angle 90°
6°
200 mm
Surface B
Surface B
Surface A
Surface A