www.usaprocom.com
200006-01B
14
NG
LP
NG
LP
FAN
HOT
NG
LP
NG
LP
INSTALLATION
Figure 12 - Assembling Base Feet
Figure 13 - Attaching Base Feet to Heater
Figure 14 - Securing Heater to Floor
Foot
Columns
Leg
Bracket
Base Cut Out
Screw
Hole
Screw
Screw
Finished
Assembly
INSTALLING BASE FEET
5. Position the heater to the desired location.
Secure the base feet to the floor by us-
ing two Phillips head self tapping screws
(provided) (see Figure 14).
GAS SELECTION
This appliance is factory
preset for propane/LP gas.
No changes are required
for connecting to propane/
LP.
Only a qualified installer or
service technician can perform
gas selection and connecting to
gas supply.
CAUTION: Two gas line in-
stallations at the same time are
prohibited. The access plate
to the simple switching means
shall not be opened while the
heater is in operation.
CAUTION: To avoid gas
leakage at the inlet of regulator,
a qualified installer or service
technician must use supplied
hex plug with sealant.
WARNING: Do not attempt to
access or change the setting of
the fuel selection means.
Access to and adjustment of the fuel selection
means must only be performed by a qualified
service person when connecting this appli-
ance to a specified fuel supply at the time of
installation.
1. Snap the left and right foot columns to-
gether (see Figure 12).
2. Place the column assembly in the center
of the base cut out. Fasten column as-
sembly by using two Phillips head self
taping screws (provided) (see Figure 12).
3. Place leg bracket on the top of column as-
sembly and fasten it by using two Phillips
head self tapping screws (provided) (see
Figure 11).
4. Align four screw holes to the base of
the heater and attach it by using Phillips
head self tapping screws (provided) (see
Figure 13).