20
*Note: Quantity depends on model of remote control.
Fig. 16 - Control Knob Position
LIGHTING INSTRUCTIONS
1. Press the OFF button to let pilot stay.
2. Turn gas control knob clockwise
to OFF position to shut off burner.
TO TURN OFF GAS TO APPLIANCE
Shutting off heater
1. STOP! Read the safety information on the front and back of the warning plate on page 19.
2. Make sure manual shutoff valve is fully open.
3. Unscrew ignitor cap and install an AAA type battery with the anode (+) pointing out.
Replace cap.
4. Install two (2) AAA size batteries in the remote transmitter.
5. Be sure the slide switch on the front of the receiver box is in the REMOTE position.
6. Push in the control knob slightly and turn clockwise to the OFF position.
7. Wait five (5) minutes to clear out out any gas. Then smell for gas around the heater and near
the floor. If you smell gas, STOP! Follow "B" in the safety information on the rating plate. If you
do not smell gas, go to the next step.
8. Push the control knob in slightly and turn counterclockwise to “PILOT” position and
depress for five (5) seconds.
Note
:
The first time the heater is operated after connecting the gas supply, the control knob
should be depressed for about thirty (30) seconds. This will allow gas to bleed from the gas
system.
9. With the control knob pushed in, push down and release the ignitor button.This will light
the pilot. If needed, keep pressing the ignitor button until pilot lights.
10. Continue pushing the control knob in for an additional sixty (60) seconds to allow the
thermocouple to warm up and to allow air to bleed from the gas system. Release the
control knob.
Note
: If the pilot goes out, repeat steps 7, 8, 9 and 10.
11. Rotate the control knob counterclockwise to the ON position.
12. Press the LEARN BUTTON on the front of the remote receiver box until you hear a beep.
13. Press the ON button on the remote control transmitter to light the burner. (This will also “learn”,
or program, the transmitter and the receiver).
14. If the transmitter is lost or damaged, the slide switch on the receiver can be used to operate
the heater.
Ignitor
Control Case
Control
Knob
On/Off
Switch
