20
TO TURN OFF GAS TO APPLIANCE
Fig. 19 - Control Knob Position
Shutting Off Heater
Turn control knob clockwise to the OFF position.
Shutting Off Burner Only (pilot stays lit )
Turn control knob clockwise to the PILOT position.
THERMOSTAT CONTROL OPERATION
The thermostatic control used on this model differs from
standard thermostats. Standard thermostats simply turn
the burner on and off. The thermostat used on this heater
senses the room temperature. At times the room may ex-
ceed the set temperature. If so, the burner will shut off. The
burner will cycle back on when room temperature drops
below the set temperature. The control knob can be set to
any comfort level between HIGH (5) and LOW (1).
Ignitor
Button
Control
knob
FAN OPERATION
Using rocker switch, turn blower on and check for operation. Turn on rocker switch to the
desired position. In the
MAN
position it will remain constantly on.
AUTO
position will be
controlled by the temperature sensor. To stop the operation turn rocker switch to the
O
position.
BATTERY INSTRUCTIONS
CAUTION
: Do not mix old and new batteries. Do not mix alkaline, standard (carbon - zinc),
or rechargeable (nickel - cadmium) batteries.
Do not dispose of batteries in fire, batteries may explode or leak.
•
Batteries are included.
• Remove batteries when depleted.
• Install/replace the batteries according to the type and quantity stated in table below.
• Do not mix old and new batteries. New batteries should be the same brand for best results.
• Be sure to observe proper polarity (+/-) when installing or replacing the batteries. Damage
due to improper battery installation may void the warranty on the product.
• For remote control systems, maximize battery life by turning off the receiver when it is not in
use.
• For long periods of non-operation, remove batteries from all components for safety.
Component
Type of Battery
Battery Qty.
Ignitor
AAA
1
Remote Control
AAA
2 or 3*
Remote Receiver
AA
4
*Note: Quantity depends on model of remote control.
