13
Attaching to Wall Anchor Method
For attaching mounting bracket to hollow walls (wall areas
between studs) or solid walls (concrete or masonry):
1. Drill holes at marked locations using 5/16-inch drill bit.
For solid walls (concrete or masonry), drill at least 1
inch deep.
2. Fold wall anchor as shown in Fig. 7.
3. Insert wall anchor (wings first) into hole. Tap anchor
flush to wall.
4. For thin walls (1/2 inch or less), insert white key into
wall anchor. Push white key to “pop” open anchor wings
(see Fig. 8).
IMPORTANT:
Do not hammer anchor key! For thick
walls (over 1/2 inch thick) or solid walls, do not pop
open wings.
5. Place mounting bracket onto wall. Line up last hole on
each end of bracket with wall anchors.
6. Insert mounting screws through bracket and into wall
anchors.
7. Tighten screws until mounting bracket is firmly fastened
to wall.
Placing Heater On Mounting Bracket
1. Locate two horizontal slots on back panel of heater (see
Fig. 9).
2. Place heater onto mounting bracket. Slide horizontal
slots onto stand-out tabs on mounting bracket.
Installing Bottom Mounting Bracket
1. Install bottom bracket to heater bottom with two screws.
It may be more convenient to remove heater from wall
bracket to attach.
2. Place heater on wall mounting bracket.
3. Mark screw locations on wall.
4. Remove heater from mounting bracket.
5. If installing bottom mounting screws into hollow or solid
wall, install wall anchors. Follow steps 1 through 4
under “Attaching To Wall Anchor Method”. If
installing bottom mounting screw into wall stud, drill
holes at marked locations using 9/64-inch drill bit.
6. Replace heater onto mounting bracket.
7. Tighten both screws until heater is firmly secured to
wall. Do not overtighten.
Fig. 7 - Folding Anchor
Fig. 8 - Popping Open Anchor
Wing For Thin Walls
Fig. 9 - Mounting Heater
Onto Mounting Bracket
Fig. 10 - Installing Bottom
Mounting Bracket
Horizontal Slots
Bottom
holes
