ENGLISH
ENGLISH
16
17
ASSEMBLY
Step 1: Stabilizers:
Will rear foot tube out to the rear portion of the frame strip holes, in bolt are sequentially
sheathed flat pad with a diameter of 10, an elastic pad with a diameter of 10 and then
set on the cap nut type, we have with the special open spanner locking (the front leg
pipe installation method).
Note: after the installation of the product may occur after the foot of the foot of the three
foot, this time can be adjusted to the foot of the black pin set to balance the product
level.
Step 2:
Remove the foot pedal, will find the foot is marked with “L”, “R”, the “R” foot on the thread
of the two drops of red thread anti loose liquid, and then to the right side of the hole,
the right side of the hole, a part of the clockwise rotation, and then we use a dedicated
open end wrench. Remove “L” foot, also on the thread of the two drop of thread against
the loose liquid, to the left side of the hole, the left side of the hole, the counterclockwise
rotation, until the turn is not moved, and then locked with a special opening.
Note: the crank is also marked with “L” and “R” with the foot pedal, if it is reversed, it may
cause a crank to damage the product. And must be locked, or with a long time after the
foot may fall off.
Step 3:
Opened the ball head of the pull pin, the cushion fixing seat upwards until the appropriate
height, loosing the ball head pull pin, the pin penetrates into the cushion fixing seat hole
after locking ball head pull pin can be (loosen the lock bolt, can move the seat cushion,
adjust to the comfortable position, the lock bolt can be).
Step 4:
The armrest fixing seat upwards, and then remove the locking bolt, penetrates into the
tight set screw thread lock, adjust the armrest fixing seat height is locked the bolt can
be locked.