cecotec CONGA 3890, Инструкция по эксплуатации

Страница: 30 / 44

30 | CONGA 3890
ENGELSK
Modes
The first time the robot is operated, it will map and save the whole house’s
map by means of its laser before starting the cleaning cycle. Use the robot
in Auto mode and Eco power level, this way you will ensure the robot
memorizes the full map.
Note: Make sure the light indicator is lighted in blue before starting cleaning,
indicating it is activated.
If not, press any button on the remote control to wake it up.
Auto mode
Fig. 14.
Press the power button on the robot for it to start cleaning automatically,
first a cleaning cycle in Edge mode and then another cycle in and organized
zigzag motion, recognizing which areas it has cleaned and which ones it has
not. The robot will automatically plan the cleaning route as it is cleaning. If
during this mode the robot is controlled manually, the robot will calculate
the route again and could go through previously cleaned areas. In order
to ensure efficient cleaning, do not operate it manually during auto mode
cleaning.
Thanks to its Total Surface 2.0 technology, if the battery is low during
the cleaning cycle, the robot will smartly return to the charging base
automatically and, once it is fully charged, it will resume the cleaning
process from the same point, offering a high-efficiency cleaning.
During cleaning, the robot will stop briefly to evaluate the area and calculate
the cleaning route (this stop will vary depending on the house conditions).
Note: The robot cleans in an organized way and per 4x4 m squared areas,
therefore it might leave the room where it is cleaning to finish off the
delimited area. Do not worry, the robot will clean all the accessible surface.
Edge mode
Fig. 15.
Press the Edge mode button on the remote control for the robot to start
cleaning under this mode. It will automatically start cleaning along all the
surface’s perimeters and then will return to the charging base direct and
automatically. If the robot has not started cleaning from the charging base,
it will return to the starting point.
Note: Press the power levels button to switch between the 3 modes:
Turbo/Normal/Eco.
Back home mode
Fig. 16.