cecotec CONGA 3890, Инструкция по эксплуатации

Страница: 27 / 44

CONGA 3890 | 27
ENGELSK
3. INSTALLATION
Robot and charging base installation
Fig. 6.
Connect the charging base to a power supply and store the remaining cable.
It is important to store the remaining cable at the bottom of the charging
base to avoid it from being dragged and disconnected.
Place the charging base against the wall, leaving the safety distance
indicated in the below picture.
Note: Ensure a space of at least 1 m on both the left and right side of the
charging base, and a space of at least 2 m in front of it.
Fig. 7.
Warning: Do not expose the charging base to direct sun light.
Long press the power button for 3 seconds; when the light indicator turns
on, place the robot on the charging base.
Fig. 8.
Steady blue light: ON/operating
Oscillating orange light: Charging
Red light blinks: Error
Notes:
Take the robot to the charging base if the battery is low. The robot might not
turn on if the battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned off during charging.
Wet & dry and dust tank installation
Fig. 9.
Recommendation: It is not suggested to use the scrubbing function for the
first-time use.
Open the tank’s blue silicone lid, fill the tank with water carefully so water
does not come out and close it again. Make sure the silicone clip is properly
closed to avoid water from pilling.
Fig. 10.
Install the tank in the robot following the indicated direction. Make sure the
clip is properly fastened.
Only for Wet & dry tank installation:
Attach the mop to the bottom part of the mop bracket with the Velcro.
Manually press the clips on both sides of the Wet & dry tank and push it into
its correct position. You will hear a click when it is properly fixed.
Fig. 11.