cecotec CONGA 3890, Инструкция по эксплуатации

Страница: 29 / 44

CONGA 3890 | 29
ENGELSK
Auto mode
Press the power button on the robot for it to start cleaning automatically,
first a cleaning cycle in Edge mode and then another cycle in and organized
zigzag motion, recognizing which areas it has cleaned and which ones it has
not. The robot will automatically plan the cleaning route as it is cleaning. If
during this mode the robot is controlled manually, the robot will calculate
the route again and could go through previously cleaned areas. In order
to ensure efficient cleaning, do not operate it manually during auto mode
cleaning.
Thanks to its Total Surface 2.0 technology, if the battery is low during
the cleaning cycle, the robot will smartly return to the charging base
automatically and, once it is fully charged, it will resume the cleaning
process from the same point, offering a high-efficiency cleaning.
During cleaning, the robot will stop briefly to evaluate the area and calculate
the cleaning route (this stop will vary depending on the house conditions).
Note: The robot cleans in an organized way and per 4x4 m squared areas,
therefore it might leave the room where it is cleaning to finish off the
delimited area. Do not worry, the robot will clean all the accessible surface.
Back home mode
Press the back home button on the robot in order to send it to the charging
base. This mode can be activated during any other cleaning cycle and the
robot will stop cleaning and return to the charging automatically.
The robot will take the shortest route back to the charging base thanks to
its map memorizing and the smart back home function. When a cleaning
cycle has been completed or the robot’s battery is low, the robot will also
return to the charging base to avoid running out of battery.
Recommendation: Remove the Wet & dry tank during charging.
5.2. Remote control
Fig. 13.
1. Schedule
2. Power levels (Turbo/Normal/Eco)
3. Back home
4. Clock
5. Manual control
6. On/Pause
7. Edge mode
The following modes and operations can be activated from the remote
control.