cecotec CONGA 3490, Инструкция по эксплуатации

Страница: 34 / 133

ENGLISH
33
4. Spiral mode
The robot is placed in a specifi c point, it moves towards the outside in a spiral motion and then
returns to the starting point in a spiral motion too. If the robot bumps into an object, it will
fi nish the cleaning cycle in the opposite direction.
5. Manual mode
The robot can be controlled manually by pressing the direction arrows on the display. While
the arrow is held pressed, the robot will keep on moving. The robot will operate according to
the suction power level and water intensity level selected on the homepage.
6. Twice mode
When this mode is activated, the robot will fi rst clean in Edge mode, then will carry out an
organized cleaning cycle in zig zag motion, then Edge mode again and another organized
cleaning cycle in zig zag motion. Once it has fi nished, it will return to the charging base, or if
it runs out of battery before fi nishing, it will recharge and the resume cleaning until fi nished.
This mode can only be activated during Edge, Scrubbing, Spiral and Smart Area modes.
7. Scrubbing mode
This robot can also scrub the fl oor. When this mode is activated, the robot moves in a swaying
motion, simulating real scrubbing moves. It starts off by Edge mode, then carries out an
organized scrubbing cycle in zig zag motion, and fi nally returns to the charging base taking
the straightest way and memorizing the route. If it runs out of battery before fi nishing, it will
recharge and the resume cleaning until fi nished.
8. Spot cleaning mode
This mode can only be activated with a previously saved map. The user must select a specifi c
spot in the map, and the robot will clean a 2 x 2 m area around the selected spot. Once it has
fi nished cleaning it, it returns smartly to the charging base, taking the straightest way and
memorizing the route. Only one specifi c spot can be selected at a time.
9. Restricted Area
This mode can only be activated with a previously saved map. This mode allows setting areas