cecotec CONGA 2690, Инструкция по эксплуатации

Страница: 36 / 168

36
ENGLISH
Modes
The following modes can be activated from the remote control:
Auto mode
From the standby mode, press the power button on the remote control and the robot will
automatically start operating. It will carry out a cleaning cycle in zigzag motion and then
another one in Edge mode.
Once it has finished, it will return to the charging base.
It is the most commonly used cleaning mode and it is used to efficiently clean the whole house’s
surface. The robot vacuums the floor’s dust automatically, in and organized and efficient way,
as it features memory and gyroscopic navigation supported by its camera.
Moreover, it changes direction when it finds obstacles throughout its route and it returns to
the charging base in a smart and direct way once the cleaning is over. It includes Total Surface
function, through which the robot cleans the whole surface and, if necessary,returns to the
charging base to recharge its battery and finish cleaning.
Edge mode
Press the Edge mode button on the remote control for the robot to start cleaning under this
mode.
It will automatically start cleaning along all the surface’s perimeters and then will return to the
charging base direct and automatically.
En caso de que el robot no hayasalido de la base de carga, volverá al punto de inicio.
If the robot has not started cleaning from the charging base, it will return to the starting point.
Back home mode
Press the back home button on the remote control. This function can be activated during
any other cleaning cycle and the robot will automatically return to the charging base and stop
the cleaning process. The robot will take the shortest route back to the charging base thanks
to its map memorizing and the smart back home function.
When a cleaning cycle has been completed or the robot’s battery is low, thanks to its Total
Surface technology, the robot will also return to the charging base to avoid running out of
battery.
Once the robot has recharged, it will resume cleaning from the point it has stopped.
Note: Remove the Wet & dry tank from the robot if it contains water before charging it.
Make sure there are no obstacles in the room being cleaned to ensure the robot can get to the
charging base without problems.
Sleep mode
If Sleep mode is selected from the robot or from the App, the robot will not operate from 10
pm to 7 am,