cecotec CONGA 2690, Инструкция по эксплуатации

Страница: 35 / 168

35
ENGLISH
Schedule
Warning: The robot cannot be scheduled from more than one device at a time. Make sure to
schedule it either from the mobile phone App or from the remote control.
The robot is provided with a schedule function in order to provide a maximum-efficiency
cleaning. Once the robot has been scheduled, it will automatically carry out the cleaning cycles
every scheduled day.
Note: If the robot is scheduled from the remote control, it can only be scheduled at the same
time every day.
Current time
Long press the time button. The first 2 digits, indicating the hour, will start blinking.
Use the up and down direction buttons to set the current time. Then, use the left and right
buttons to switch from hours to minutes and repeat the before step.
Press the time button to save the settings.
Cleaning scheduling
Long press the schedule button. The first 2 digits, indicating the hour, will start blinking.
Use the up and down direction buttons to set the current time. Then, use the left and right
buttons to switch from hours to minutes and repeat the before step.
Press the schedule button again to save the settings.
To cancel the scheduled cleaning:
Set the clock on the remote control to 00:00 am and save it.
Switch the robot off for 1 minute and switch it on again.
Note: The robot will beep to indicate all settings have been saved.
Warning: When the remote control’s batteries are replaced, the clock and schedule times must
be set again.
Standby
The robot will automatically enter standby mode after 5 minutes of no operation.
Press on the App, the remote control or on the robot to start it up again.
Note:
After 12 hours of no operation, the robot will turn automatically off.
The robot will not enter standby mode during charging.
Suction power level
Press the suction power button on the remote control or on the App to select the desired
power level.
Choose between Eco (low power), Medium (medium power) and Turbo (high power).
High power