READY WARM 9870 SMART ROTATE
READY WARM 9870 SMART ROTATE
27
26
ENGLISH
ENGLISH
Timer setting
The device includes a 24-hour programmable timer.
The timer can be set from 1 minute to 23 hours 59 minutes.
Once the programmed time has elapsed, the device switches off and END appears on the display.
Press the timer button. The hour indicator will blink.
Press the + and – buttons to set the desired hour.
Press the timer button again.
Press the + and – buttons to set the desired minutes.
Press the timer button again to save the settings.
The set time will show up on the display.
Oscillation function
Press the oscillation button to activate and deactivate the oscillation function. The device
oscillates from one side to another, spreading warm air.
Protection against overheating
The device turns automatically off when its temperature becomes too high. If this happens:
Turn off the power switch.
Allow the device to cool down.
Check if the air inlet or outlet is obstructed and clean it.
Safety switch
The device includes a tip-over safety system which automatically turns off the device when it
tilts or when it is lifted.
Frost protection
When this function is activated, the device automatically turns off when the room
temperature falls below 6 ºC and will remain on until it reaches 9 ºC.
Press the mode button repeatedly until the frost-protection mode symbol appears on the
display to activate it and press again to deactivate it.
4. CLEANING AND MAINTENANCE
Always turn off, unplug and allow the appliance to cool down before cleaning.
Do not use abrasive scouring pads, powders or cleaners to clean the product.
Use a soft, dampened and clean cloth to clean the product’s outer housing. Be careful not to
touch the heating elements.
If the heater is not going to be operated for a long period of time, store it in a dry and safe
place where it is protected from dust.
Check for any visible damage, if any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
Place the heater on a flat and stable surface.
3. OPERATION
As soon as the appliance is turned on, the display will light up.
The device can be controlled from the control panel.
Switching on/off the device
Connect the mains plug into a power outlet.
Turn the power switch on in order to turn the device on. The power switch and the display will
light up, indicating the device has entered standby mode.
Press the power switch to enter operating mode. The indicator light will turn on.
Press the standby button to switch back to standby mode once operation is over.
Turn the power switch off to switch off the device completely.
Modes settings
Press the mode button repeatedly to select the desired operating mode.
Fig. 4
Low-power heat (1000 W).
Fig. 5
High-power heat (2000 W)
Fig. 6
Automatic mode: The device adapts the heat
power to the room temperature.
Fig. 7
Frost protection: The device turns
automatically on when the room temperature
is below 6º.
Temperature adjustment
The desired temperature is shown on the display (above the room temperature).
Use the + button to increase the desired temperature up to 38 ºC and the – button to
decrease it down to 6 ºC.
The room temperature is measured by the temperature sensor and shown on the display.
The device includes a thermostat which automatically switches off the device when the room
temperature has reached the set one.
If the room temperature falls below the set one, the device will switch automatically on again.
