![cecotec 05680 Скачать руководство пользователя страница 25](http://html1.mh-extra.com/html/cecotec/05680/05680_instruction-manual_2578530025.webp)
CONGA ROCKSTAR 2000 ULTIMATE-ERGOWET CONNECTED
|
25
ENGLESK
- Once the wall charging base is installed, the charging port must be
connected to the power adapter, and then the device can be charged by
sliding it from top to bottom into the wall charging base. Fig. 5
Charge and display
- When the battery percentage is 20 % or below, the device will automatically
enter low consumption mode. It is recommended to charge the device
when it reaches this percentage.
- The battery must be charged on the fast charge base while connected to
the device. Connect one of the ends of the power adapter to the power
supply and the other to the fast charge base. Fig. 6
- During charging, the charge light indicator will turn on red and the display
will show the current charge percentage. When the device is fully charge,
the battery indicator will turn green and the display will show 100 %. Fig. 7
- It can also be charged without the fast charge base when the battery
is installed in the device or when it is outside. Connect the adapter and
connect the other end to the battery, paying attention to the direction.
Once it is properly connected, the charge light indicator will turn on red
and will turn green once the charge is competed. Fig. 8. Fig. 9
Using the handheld vacuum cleaner
1. Press the On/off button to turn the device on and off.
2. Press the speed control dial to select the device operating speed: Low,
Medium, High or Smart. The device will operate in ECO mode by default
and will display “LOW”. The battery percentage and sync will also be
displayed.
3. Press the speed control dial to set the device at medium speed. “MED” will
be displayed on the screen. The battery percentage and sync will also be
displayed. 2/3 of the opening radius will be shown (vacuuming).
4. Press the speed control dial to set the device at high speed. The screen will
display “HIGH”. The battery percentage and sync will also be displayed.
The vacuuming opening radius will be completely shown.
5. Press the speed control dial to set the device at Smart speed. Under this
mode, the device will automatically adjust suction power according to
the concentration of dust and the type of surface. The screen will display
“AUTO. The battery percentage and sync will also be displayed. The screen
will display: the amount of absorbed dust, 1/3 when the concentration
opening radius is low, 2/3 when the concentration opening radius is
medium and the full display when the concentration opening radius is
high.
6. When operating at high speed and the battery is 20 % or lower, the
device will automatically switch to medium speed in order to lengthen