![cecotec 05680 Скачать руководство пользователя страница 24](http://html1.mh-extra.com/html/cecotec/05680/05680_instruction-manual_2578530024.webp)
24
|
CONGA ROCKSTAR 2000 ULTIMATE-ERGOWET CONNECTED
ENGELSK
3. PRODUCT ASSEMBLY
Vacuuming tube and suction base assembly
- To install the suction base into the vacuuming tube, align both of them
making sure the tab on the suction base matches the guides on the tube,
and introduce one into the other until they are firmly fixed. To disassemble
them, press the suction base release button and pull from the vacuuming
tube while you hold the suction base.
- Warning: When assembling these 2 parts, make sure the handle and the
brush are facing the same direction.
- Use the Flex tube to reach and vacuum dirt from the most inaccessible
zones. Press the Flex button to bend the tube. Fig. 2/2.1/2.2
Battery assembly
- Introduce the battery in the slot located in the handheld vacuum cleaner
following the guides. Once it is introduced, it will click into place. Move it
slightly to ensure it is properly assembled in place.
Note
- Take the battery out and store it in a safe, dry place if the device is not
going to be used in a long period of time. Fig. 3
- Following the below illustration, keep the vacuuming tube vertically, align
the tab on the vacuuming tube with the guides in the handheld vacuum
cleaner and introduce the tube.
Fig 4.
4. OPERATION
Wall charging base installation
- First, fix the wall charging base. To do so, we recommend you place a
protective film (not included) on the wall’s surface. Then, put the charging
base on the wall and make 3 corresponding to the holes to be drilled in
order to fix the base. Take into account the height of the installation, it is
important that suction base rests on the floor to avoid the charging base
from holding all the vacuum cleaner’s weight. Make 3 holes on the wall
and fix the charging base with the supplied M4 x 32 nuts and screws.
- It must be installed at 102,5 mm from the floor.
- Make sure that the charging base is securely fixed on the wall, place the
vacuum cleaner on the charging base as shown in figure 5 by putting
the vacuum cleaner’s charging terminals into contact with the charging
base’s ones (plastic tab).