cecotec 05613, Инструкция по эксплуатации

Страница: 19 / 24

ENGLISH
2
.PARTS AND COMPONENTS
Fig. 1.
1. Steam outlet
2. Display
3. On/off button
4. Warm mist button (Plasma function)
5. Speed button
6. Timer
7. Humidity button
8. Light
9. Water tank
3
. BEFORE USE
Take the product out of the box.
Remove all packaging material and save the original box.
Make sure all parts and components are included and in good conditions. If any visible signs
of damage are observed, contact the Technical Support Service immediately.
4
. OPERATION
Note: The ideal relative humidity level for human comfort is between 45 % and 65 %. Excess
humidity shows up in the form of condensation on cold surfaces or cold walls in the room. To
measure the room’s humidity correctly, use a hygrometer.
Relative humidity in different environments suitable for people:
Bedroom, living room: 45-65 % RH
Patient’s room: 40-55 % RH
Room with computer, experiment equipment: 45-60 % RH
Room with piano: 40-60 % RH
Museum, exhibition hall, and library: 40-50 % RH
Place the device on a flat surface.
Filling the water tank
Remove the device’s top cover and remove the water tank with the handle. Turn it upside
down on a flat and dry surface. Disassemble the nut by turning it anticlockwise. Fill the tank
with the desired level of water and close the tank again with the nut, turning it clockwise. Use
the handle to assemble the water tank back on the product.
Plug the device to a power supply. The display will light up and the device will beep. After 1
second, the display will turn off and the device will enter standby mode.
Press on/off, the device will start working under mist mode at level 2. The blue light indicator
will turn on. The control panel will display the current humidity.
Mist speed
While the display shows current humidity, press the Max./Min. button to check the current
mist speed. Press repeatedly to set the desired speed. There are 3 different settings.
Constant humidity
When the LED display is showing current humidity, press the Humidity symbol.
The humidity level can be set from 30 % RH to 90 % RH.
Every time the symbol is pressed, it will be increased by 5 %.
When it reaches 90 %, press again and the display will show “Co”. Do not operate the device
for 3 seconds to cancel the humidity setting function.
Note: If the target humidity is higher than the current humidity, the humidification function
will work.
When the target humidity is lower than the current humidity, the device will enter standby
mode.
Note: The mist speed cannot be adjusted under constant humidity function.
During operation, hold down the humidity symbol for 2 seconds to turn the blue light
indicator and the display on. Touch the symbol again to turn it off. After 15 seconds of no
operation, the light indicators and display will turn off.
Timer
There are 12 timer settings: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,11, 12 hours.
Press the Timer symbol repeatedly to select the desired operating time.
Press the Timer symbol until “-- --” is displayed or hold down the Timer symbol twice to
cancel the timer.
Once the timer is set, do not touch any button and setting will be automatically saved after 5
seconds. After 1 minute, the display will show the current humidity.
The display will show the remaining time every hour.
Warm water mist
Press the Warm mist button to turn the warm mist function on and off. The warm mist
function indicator will light up.
Note: This function is not available when there is no water in the tank or when it is running
under a non-humidifying mode.
ENGLISH
BREEZECARE 4000 CONNECTED BREEZECARE 4000 CONNECTED
36 35