Cappuccino Dispenser - Vertical Door
Cecilware
®
9
Maintenance
Lit Display, Bulb, and Starter Replacement
To replace the fluorescent bulb:
1. Remove the upper inside door panel.
2. Unscrew the lamp and pull it out of the lamp holder.
3. Place the new lamp into the lamp holder and screw it
into position.
To replace the lamp holder:
1. Remove the upper inside door panel.
2. Push the socket firmly to one side.
3. Untie the clip, clear the hole in the bracket, and lift up.
4. To install the new socket, put one side of the lip into the
hole and push the socket to one side until the second
clip snaps into the second hole.
To replace the picture inside metal door:
Recommended preventive maintenance
1. Dispense
Valves
• Check all dispense valves for lime build-up.
• Drain the water tank to just below the
level of the dispense valves.
• Remove the valves and clean. (Take these
valves apart by hand as shown).
• Replace the assembly as needed.
• Replace the valve into the tank and refill
tank.
WATER
FLOW
AD
J
USTMENT
WARNING
Risk of electrical shock. Turn off power to
unit before replacing bulb or starter.
P
RODUCT
LABEL
1. Lift up the two end tabs on
top of door with a pointed
object or flat head
screwdriver.
2. Pull the entire picture frame
out. Open the two clear
panels and replace picture.
3. Tuck clear plastic panel
inside bracket at top.
4. Be sure to tuck clear panel
under bracket before sliding
frame assembly inside door.
5. The longer metal tab side
goes in the front.
