Cebora 436.00., Инструкция по эксплуатации

Страница: 15 / 32

3301121 15
EN
6 USER INTERFACE
Once the power source has been installed, the kit is recognised automatically. An example
of the user
interface is given below. (WIN TIG).
On the Home screen, select
“Accessories”
Set
“Gas Regulation Kit”= ON
Go back to the Home screen and select
“Process Parameter”
Select
“Gas Flow”
Use the encoder to set the flow rate
“l/min”
The Gas Flow parameter is the set-point flow to be implemented by the regulator. The regulator is set to
Argon gas as standard. This means that setting a Gas Flow of 1 l/min gives an Argon gas output of 1
l/min.
If using gas other than Argon, enter a correction factor (as shown in the table in Chapter 7) and obtain the
gas flow parameter setting using the following equation:
t coefficien Correction
new GasFlow
GasFlow
_
_

GasFlow_new = new gas set-point value
Correction_coefficient = correction value for the new gas in the table given in section 7
Example: If the new gas is CO2 and the required setting is 2 l/min then:
5 , 3
57 , 0
2
 
GasFlow
l/min value to be set on the display if required CO2 flow is 2 l/min.