Ceasa SET&SOFT, Инструкция по эксплуатации

Страница: 16 / 33

16 SHOWER SOFTENER-CEASA
Below are the installation steps for installation before the water heater
Install the cold and hot water connectors
a. Shut off the water supply, remove the water mixing valve with a wrench,
keeping the center distance of the eccentric connection invariable, as shown in
figure 10.
b. Take out the cold and hot water connectors and ¾" flat gasket from the
accessories box. Refer to the chart to remove the cold and hot water connectors
installed on the wall from the eccentric connections, taking care not to damage
the flat gasket, as shown in figure 11.
c. Use the wrench to connect the cold water connector of the water mixing valve
to the cold water connection, and the hot water connector to the hot water
connection, taking care to maintain the integrity of the flat gasket, as shown in
figure 12.
d. Following the diagram of the installed water mixing valve and the signs on the
connection, place the cold water outlet facing down, as shown in figure 13.
e. In order to prevent large particles from entering into the softener from the
pipeline, which could affect the operation, we suggest that users install a cut-off
filter valve. Take out the cut-off filter valve and flat gasket, tighten the cold
water connection to the tap water connection, placing the flat gasket as shown
in figure 14. Appearance after installation is shown in figure 15.