16
How to Install the Hob
Overall dimensions of the hob:
Width: 300mm Depth: 510mm
Worktop cut-out dimensions:
Width: 268mm Depth: 500mm
1. Make the required hole in the
worktop. Before doing this, you must
check the instructions supplied with
any cooker hood to ensure that you
will have the required clearance. The
cut-out (Fig. 6) shows a 60mm gap
from the wall to the cut-out edge.
The distance from the hob, when
fitted, to the back wall is 50mm. If
a splashback/worktop upstand is
to be fitted, take this into account
when cutting the hole. The minimum
distance that the hob should be
positioned away from the rear wall or
splashback is 50mm.
2. Position the hob seal, as shown in
Fig. 8, ensuring that the ends meet
without overlapping. Do not use
silicone type sealant.
3. Secure the hob to the worktop using
brackets and screws supplied, as shown in Fig. 9. Remove any
excess sealant after tightening the brackets. Do not over-tighten
the fixings.
Fig. 9
Fig. 8
Fig. 7
400mm
600mm
600mm minimum
(650mm recommended)
