34
Connecting to the mains water supply
•
Fit the seal included in the hose packing at the end of the water
inlet hose on the tap side.
•
Connect the water inlet hose to a 3/4” BSP water tap. Then securely
tighten the connecting nut by hand.
•
After connections are completed, check there are no leaks from the
connection joints by turning on your tap completely.
For your washing machine to work properly, the mains water
pressure must be between 0.05 and 1MPa (0.1 - 10 bar).
Drainage connection
•
It is recommended that you have a fixed drainage outlet 80 to 100
cm from the floor.
•
Avoid the drain hose being too tight, kinked or restricted.
•
The water outlet can either be connected to a water drain or to a
sink outlet spigot (ensure the spigot is cut/opened). This connection
should be a minimum of 80cm and a maximum of 100cm from the
floor. The drain hose should be no longer than 4m in length to
ensure good performance from the washing machine.
•
After connecting the water supply, check to ensure there are no
leaks.
min
80 cm
max
100 cm
Fig. 17
Содержание CI327
Страница 1: ...CI327 Integrated washing machine Installation use and maintenance ...
Страница 24: ...24 Fig 8 Fig 9 Fig 10 Fig 11 Fig 12 Fig 13 ...
Страница 40: ...40 CP Fig 22 Fig 23 Fig 24 ...
