10
Replacement of Batteries
Remove the battery cover plate from the rear of the remote control, by sliding it in the direction of the arrow.
Install the batteries according the direction (+and -)shown on the Remote Control.
Reinstall the battery cover by sliding it into place.
Use 2 LRO 3 AAA (1.5V) batteries. Do not use rechargeable batteries.
Replace the old batteries with new ones of the same type when the display is no longer legible.
Do not dispose batteries as unsorted municipal waste.
Collection of such waste separately for special treatment is necessary.
1. Direct the remote control toward the Air conditioner.
2. Check that there are no objects between the remote control
and the Signal receptor in the indoor unit.
3. Never leave the remote control exposed to the rays of the sun.
4. Keep the remote control at a distance of at least 1m from the
television or other electrical appliances.
Note
Child-lo
ck:
Press a
nd
Togethe
r to acti
ve
Display
ON/OFF
:
Long pr
ess ECO
b-
utton.
Please r
emove b
a-
Tteries
to avoid
le-
akage d
amage w
-
Hen not
using fo
r
A long t
ime.
Note
Child-lock:Press and
together to active.
Display ON/OFF:
Long press ECO button.
Please remove batteries
to avoid leakage damage
when not using for a long
time.
Signal
receptor
Each time when you insert the batteries for the first 3 minutes, turn off the remote control, then you can
program it for (only cooling) or (cooling and heating) type.
1. Press and hold MODE button over (5seconds) to access the change mode to COOL or HEAT;
2. Press and hold the MODE button, until it swtich to COOL or HEAT;
NOTE: If you adjust the remote control in cooling mode, it will not be possible to activate the heating
function in units with a heating pump . If you need to reset, take out the batteries and install again.
3. Then release the pressing and wait for 5 seconds, the function will be selected.
O
O
You also can program the temperature display switch over function between C and F.
1. Press and hold the TURBO button over (5seconds) to get into the change mode;
O
O
2. Press and hold the TURBO button, until it switch to C and F;
3. Then release the pressing and wait for 5 seconds, the function will be selected.
REMOTE CONTROL
Содержание 292871
Страница 31: ......
