CCTV JE900BN, Руководство пользователя

Страница: 23 / 24

22
Part IV: Appendix
Simple troubles and corresponding solutions
Problems Possible causes Soluition
Wrong connection of power cables Correct
Power supply damaged Replace
Not required power type Replace
No action, no picture, indicator not
on when power is switched on.
Bad power cable connection Correct
Address or Baud rate setup wrong Set up again
Protocol setup wrong Set up again
Normal self-check and image but
out of control
RS485 bus connection wrong Check RS485 bus connection
Mechanical failure Repair
Camera inclined Reinstall
Abnormal self-check image with
motor noise
Power supply not enough Replace, placing the adaptor nearby
the unit is recommended
Bad connection of video Correct
Unstable image
Power supply not enough Replace
Power supply not enough
Replace, placing the adaptor nearby
the unit is recommended Some dome camera out of control
or control delayed
Matching resistor is not equipped in the dome
camera at the farthest end
Install matching resistor in the dome
camera
Weak 485 signal; not enough power in 485
transformer
Replace with thicker controlling
cable. Replace transformer
PART V. CONNECTING SKETCH