CBE PC380-BS, Руководство пользователя

Страница: 21 / 60

21
FUNCTIONS
Alarm goes off when the voltage goes above 12.5V.
When leisure battery voltage reaches 11.5V the
leisure battery reserve alarm goes automatically on,
the symbol ref. 17 starts blinking, you hear a short
beep.
Alarms go off when the voltage goes above 12.5V.
The control panel automatically turns off with a
voltage lower than 9.5V.
CAR BATTERY ALARM (B1)
This device doesn’t control the the 12V users
connected directly to the leisure battery B2
.
When car battery voltage goes below 12V Car
Battery Discharge alarm goes on and the symbol ref.
16 starts blinking. ,
When the leisure battery voltage reaches 10.5V, the
Leisure Battery Discharge alarm goes automatically
on, the symbol ref. 17 starts blinking, you hear two
short beeps.
The electronic battery protection device disconnects
the 12V users when leisure battery reaches 10V and
disables: pump, lights,
, awning light
stove.
exit RH “ ”, TV
sockets and
Users are automatically reconnected with a voltage
higher than 13.5V.
LEISURE BATTERY ALARM (B2)
It is possible to connect all users for one more
minute by pressing the on/off button (ref. on
control panel)
5
.
Symbol ref. 15 is the visual alarm signal.
MINIMUM VOLTAGE CONTROL (BATTERY
PROTECTION)
Alarm turns on when water level exceeds
90% of total capacity and turns off automatically
when level is lower than 80%.
waste
Alarm is acoustic (when engine is off) visual ,
( blinking) symbol ref. 14 .
WASTE WATER TANK ALARM
- Measure range is: -40A ÷ +40A.
graphically by the level guage ref. 11.
b) Waste water tank with electronic probe:
visualization in % (steps of 10%) .
a) Fresh water tank w ith electronic probe:
visualization in % (steps of 10%) and
FRESH WATER TANK ALARM
A fresh larm turns on when water level goes below
1 % of the tank capacity and automatically turns off
when level exceeds 2 %. 0
0
A ,
( blinking)
larm is acoustic (when engine is off) visual
symbol ref. 13 .
AMMETER
- Measure is carried out as difference between
charging and discharging currents: a positive value
indicates a charging current, a negative value
indicates a discharging current.
The ammet is inside the DS520-AN module. er
- It measures the current of the leisure battery,
users’ consumption and recharge through
battery charger, engine alternator and solar
panels.
To measure the charging of a sole source (battery
charger, alternator or solar panels), turn off all
users and other recharging sources.
To measure the consumption of a sole user,
disconnect all recharging sources and all
uninterested users.
TANKS
EN